|
|
|
Support
Mid-Range Fold Adjustment |
|
|
The Pickoff should only feed one sheet of paper at a time. If the
pickoff is feeding two or more sheets at a time or no paper at all,
then adjustment is necessary. Adjustment of the pickoff is done
by turning the thumbscrew counter clockwise if it is picking two
sheets. Then turn Clockwise if it isn't picking any.
|
Wick Adjustment
If forms do not seal completely, identify the wick in need
of adjustment and move the red adjuster one notch closer to
the sheet. If the form is too moist, move the adjuster away
from the sheet. If wicks are dry, remove them and soak in
hot water. For wick removal see next step.
|
Wick Replacement
Over time the wicks become worn and must be replaced. Remove
the thumbscrews from each reservoir lid and remove the wicks.
Replace the wicks with the adjuster tab facing up and the
tapered and tail of the wick in the water.
|
Glue spots trail edge into the Folder/Sealer
Form direction into sealer.
|
Correct fold setting.
|
Left Buckle Chute Setting
First fold too long. Loosen thumbscrews and move buckle stop
down. (See step 2)
|
Left Buckle Chute Setting
First fold too short. Loosen thumb screws and move buckle stop
up. (See step 2)
|
Second fold too long. Loosen thumb screws and move buckle stop
up. (See step 3)
|
Second fold too short. Loosen thumb screws and move buckle stop
down. (See step 3)
|
©
2002-2010, Infoseal.
Infoseal, LLC • 1825 Blue Hills Circle • Roanoke, Virginia •
24012 • 1.888.952.4636 • Fax 888.652.4636
|
